The IOS operating system then initializes the interfaces using the Cisco IOS commands found in the configuration file, startup configuration, which is stored in NVRAM. On Catalyst 2960 Series switches, the image file is normally contained in a directory that has the same name as the image file (excluding the. In a depth-first search of a directory, each encountered subdirectory is completely searched before continuing the search in the original directory. If this variable is not set, the switch attempts to load and execute the first executable file it can by performing a recursive, depth-first search throughout the flash file system. The boot loader finds the Cisco IOS image on the switch using the following process: The switch attempts to automatically boot by using information in the BOOT environment variable. Finally, the boot loader locates and loads a default IOS operating system software image into memory and hands control of the switch over to the IOS. The boot loader initializes the flash file system on the system board. It initializes the CPU registers that control where physical memory is mapped, the quantity of memory, and memory speed. The boot loader performs low-level CPU initialization. The boot loader is a small program stored in ROM and is run immediately after POST successfully completes. Next, the switch loads the boot loader software. It tests the CPU, DRAM, and the portion of the flash device that makes up the flash file system. First, the switch loads a power-on self-test (POST) program stored in ROM.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |